Description
These are 1 inch, 3/4-inch or 1/2-inch Beastee Dee® Rings. They are very strong and can take the tip of a hiking pole to put your tarp in porch mode. They weigh just .43 grams each. Great as a finishing touch for your DIY XENON tarp.
Specs:
- 1/2-inch Beastee Dee® Ring: interior hole diameter 1/4-inch or 6mm
-
3/4-inch Beastee Dee® Ring: interior hole diameter 3/8-inch or 10mm
-
1-inch Beastee Dee® Ring: interior hole diameter 9/16-inch or 14mm
CSH –
What is the diameter of the hole on the 1/2″ beastee dee rings?
Carolyn –
about 1/4″
lepine.martin –
To be functional with the majority of trekking poles, would it be best to use the 1″ or 3/4″ rings on the tie outs for either porch mode or going to ground? Just looking to get some advice before grabbing the grosgrain and d-rings.
umana.juanignacio –
I need to use the ring to fit the end tip of a tent pole that is 5/16″ (8 mm) in diameter, what ring will it work for this?
Carolyn –
If the tip is 5/16″ is literally a toss up between the 1/2″ and 3/4″ beastee d ring. The opening on the 1/2″ was about a 1/4″ and then the 3/4″ I believe will be to big.
zwshap –
What is the diameter of the hole in the 1” beastee?
Carolyn –
14.5mm or a little over a 1/2″
simonkemp –
Can a Hookworm fit over a 1/2″ dee ring?
Carolyn –
no
Jeffery Stroud –
Would a tato tarp connector be able to slide the plastic end through the 1 inch beastee d-ring? Thank you 🙂
Dave Gantz –
Yes, the T-end will fit, when turned, through this D-ring.
bearcwy –
What size grosgrain should I use on the Beastee Dee’s?